Buy Low Price From Here Now
2 Channel Power Amplifier providing 100 watts of power per channel.
Readmore
Technical Details
- 100 Watts per Channel Minimum into 8 Ohms, 2 Channels Driven, FTC- Auto power on/off
- High current, low impedance drive
- Preamp-level input-output loop
- 12volt trigger and input level adjustment
See more technical details
By Christopher B. Cutter (Louisiana)
Got this to replace the Pyle amp that died after a couple of days. I only use it to power two small speakers in the back yard as part of a remote system hooked up to an old HK receiver. It is clearly capable of much grander status but I couldn't found a cheaper one that I felt would last. In my experience the well-made Jap amps last twnty years plus and are usually bullet-proof to screw-ups in our power supply or speaker short outs.
By Robert Borzelleri
I had this amp set up to power a distributed stereo signal to feed the rest of the house for background music. While it worked for the warranty period reasonably well, it did shut itself off for reasons that never were readily apparent.
Then one day, it tripped off never to come on again. Onkyo service is an exercise in all that is bad with customer service for electronic equipment. If it's out of warranty by even a day, the nature of the discussion with the service tech becomes akin to wading through sludge.
Bottom line, it would cost more to fix it than the cost of a new one. It is a door stop and I bought two Audiosource amps and am quite happy, thank you. I am done with Onkyo.
By Vitius Altius Fortius (California)
Excellent product and great price. Clean and crisp power to speakers. Minimal heat generation. Highly recommended.
By Thomas N. Wheeler (Raleigh, NC)
I purchased this amplifier to replace a center channel amplifier in my home theater system. The previous center channel amplifier had been very expensive (>$2500) and had totally failed after only 7 years of service. The M-282 has turned out to be an excellent and inexpensive replacement amplifier. It works exactly as described. I have no audible hum coming from the unit. It is totally quiet. It runs so cool that I can barely feel any warmth on the top of the unit. The auto power feature works beautifully and turns on within 1 sec of an audio signal being sent to the amp. The sound quality of my Aerial Acoustics C3 center channel speaker when powered by the M-282 is indistinguishable from its sound quality when powered by the amplifier costing 10X as much. I am totally pleased iwth the M-282.
Tom
By Eric Sandbagger (Seattle, WA USA)
About the only thing I didn't like about my 40-inch Sony LCD HDTV (KDL-V40XBR1) was the undistinguished sound of its built-in speakers. I solved the problem with this Onkyo power amp in combination with a pair of Polk Audio Monitor 40 2-way bookshelf speakers. The audio output of the TV is fed into the RCA-type audio input of the Onkyo amp. I set Onkyo's volume control (placed on the back of the unit) about a half-way point, and control TV's volume with the Sony TV remote. The resulting sound is much better than the low-fi sound from the TV's built-in sound system -- richer and better defined. The Onkyo amp just sits on a lower-level of the TV stand; I don't have to do anything with it. My black Onkyo unit is almost invisible. When I power up the TV, in a few unnoticeable seconds the Onkyo amp's IDLE mode changes to ON mode, and the sound comes out of the Polk speakers. When I turn the TV off, the amp returns to the idle mode. It's as though the Onkyo power amp were built into the TV. I don't detect any noticeable hum from it, and it does not generate excess heat, as some reviewers complained about. For my rather basic needs, this is an ideal solution. I am totally satisfied with this Onkyo power amp.
Images Product
Buy Onkyo M-282 2-Channel Power Amplifier Now
No comments:
Post a Comment